Specification:
Chassis and fittings etched in 0.018" brass
Levers 4" long from fulcrum to handle, cast in hard brass
Pre-drilled holes for fulcrum and axle
Four drive holes per lever, allowing fitting of mechanical or electrical locking
Suitable for surface or recessed mounting - both types of mounting plate supplied, as shown

This kit is the original MSE 14-lever frame. If you require a smaller or larger frame, please see kit SM2, which has a half-spacing at each end to allow for the joining of frames whilst keeping a regular spacing between the levers.

All parts needed to construct the frame shown in the photograph are supplied in the kit, except the wooden base and fixing screws.